Sharp WH-236E Service Manual page 12

1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect 3 lead wires from the triac.
3. Remove 2 screws holding to the heater tank ass'y.
4. Now the triac is free.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect reed SW. lead wires from the PCB-1.
3. Remove 2 screws holding the reed SW. from the body valve.
4. Now the reed SW. is free.
Note : Tighten the mounting screws of the reed switch at the specifi ed torque ; 3-4 kgf.cm.
Body valve
REMOVE OF TRIAC
Breaker lead wire
Screw
Triac
REMOVE OF REED SWITCH
Screw
Reed SW.
White lead wire
Brown lead wire
Triac lead wire
Fig. 24
Fig. 25
12
Heater tank
Reed SW. lead wire