Siemens SINUMERIK 840D sl Upgrade Instructions page 5

SINUMERIK 840D sl
please check the settings made under Control Panel / Set PG/PC Interface. In addition to S7ONLINE, an
Access Point
SINUMERIK_CP (SINUMERIK 7xx) -> TCP/IP -> VIA Rhine III Fast Eth. ..<Board 2>
must be included. If necessary, configure this Access Point as indicated.
•
Editor: The key combination Shift+Insert must be used to edit cycle calls directly in the DIN code. At present,
this is not provided on all SINUMERIK OPs. Remedy: Use an external PC keyboard.
•
With the installation version "Operation on SIMATIC-CPU 317 / 319", the internal editor is not functional. Use
an external editor (e.g. notepad, wordpad).
•
To operate the simulation NC-MD $MC_FRAME_ACS_SET must be set to 1.
© Siemens AG 2010
Upgrade Instructions
SINUMERIK Operate 2.6 SP1 HF3 for PCU 50.3
2010-11-26
Page 5 of 5