Using The Monitor Set; Connecting To A Rgb Cable - LG L1710LT Owner's Manual

USING THE MONITOR SET

Connecting to a LAN Cable
LAN Cable
(Not included)
Switching
hub
LAN Cable
(Not included)
2nd POS (Monitor)
Option
NOTE
The LAN and USB cables are optional. You can purchase them from an electronics store, online
y
stores, or your local LG stockist.
You can connect up to five monitors to the host POS. If you need to connect more monitors than the
y
number of ports in the router, use the switching hub to connect.
CAUTION
The display link and EST network USB setting utility should already be installed before connecting
y
the power cable for the 2nd POS (monitor).
As of April 2011, the host POS authorized by the network POS is the HANASIS MICUS37 model.
y
For additional models, visit http://networkmonitor.lge.com.
The warranty does not cover any damage caused by the use of products other than the authorized
y
host POS.
2nd POS (Monitor)
Router
LAN Cable
(Not included)
Host POS
USING THE MONITOR SET
AC-IN LAN
LAN Cable
(Not included)
Not included
1
Connect the router or switching hub to the
monitor with a LAN cable.
2
Remove the power cable from the 2nd POS
(monitor).
3
Install the display link and EST network USB
setting utility onto the host POS, and then
reboot it.
4
Connect the power cable to the 2nd POS
(monitor).
5
Install the LG network service driver, and check
that the screen blinks as many times as the
number of 2nd POSs (monitors), and then
reboot it.
6
Check that the 2nd POSs (monitors) operate
normally and also that the touch response
works properly.
7
Install SoftXpand Xpress.
9
SERVICE
USB Cable
(Not included)