Power Mode - GE ERESCO MF4 Series Operating Manual

2.4

Power mode

In power mode, the shortest exposure time that can be achieved with the maximum tube
output is calculated.
To switch on the power mode, parameter input must occur as described in section 2.3
according to the exposure diagram (see appendix) in the following order:
Example:
For power optimisation, press the F5 key P:
The unit calculates the shortest exposure time that can be achieved with the maximum
tube power.
The shortest exposure time set by the unit is 30 sec.
NOTE:
Copyright by GE Sensing & Inspection Technologies GmbH
08/24/2016
6. Edition, ID No.: 37020GB-F
Operating Manual ERESCO MF4 Type Series
In case of low mains voltage (< 204 V or < 107 V), the nominal values cannot
be achieved, depending on the output power.
The unit then switches off with message 124: reduce power .
Remedy: Reduce the power by approx. 20% and increase the exposure
time correspondingly.
1. kV = 90,
2. mA = 4.5,
3. min = 5.0.
Bogenstrasse 41 D - 22926 Ahrensburg
27