Data Writing; Writing The Flash Id Serial Number Check And Rewriting - Sony PEG-UX50 Service Manual

Note: A writing method of Magic Gate ID is not mentioned in this manual because of the license reason.
4-1. WRITING THE FLASH ID
SERIAL NUMBER CHECK AND REWRITING
Equipment used:
• PC (Windows 2000 installed)
• Writing tool soft_UX50U : J-2507-581-
• Writing tool soft_UX50E : J-2507-582-
• Writing tool soft_UX40U : J-2507-586-
• USB cable (E45SERIES "Mini-B")
• Memory Stick (MS) : More than 4MByte
• AC power adapter : PEGA-AC10
• Charger cradle : PEGA-JC40
4-1-1. Connection
1 USB cable
CLIE
CRADLE
AC Adaptor
1. Connect the CLIE and the PC with the "USB cable".
2. Connect the "Charger cradle" to the CLIE.
3. Connect the AC adapter.
4-1-2. Preparation
1. Use the PC which "Palm desk Top" for PEG-UX50 or PEG-
UX40 is not installed in.
2. Copy the "Writing tool soft_UX50
\FlashIDUSB\CLIE\IDTool.prc" to the "Palm\Launcher"
folder in the "Memory Stick".
3. Install the USB drivers under the "Writing tool soft_UX50
(or _UX40U)\FlashIDUSB \Driver" in the PC.
SECTION 4

DATA WRITING

*
*
*
1
PC
*
(or _UX40U)
4-1-3. Serial Number Check
1. Turn on the Power switch of CLIE if connection is completed.
2. Start the following "Writing tool soft" on the PC.
• Writing tool soft_UX50
FlashIDUSB.exe
3. Insert the "Memory Stick" into the CLIE. Tap the "ID Tool"
icon on the "Launcher screen".
4. Current model ID number and serial number are displayed
in the READ text box of Flash ID dialog on the PC. However,
if the Flash ID has not been written yet, "There doesn't exist
ID" will be displayed.
4-1-4. Serial Number Rewriting
(Successively, perform the following)
1. Fill in the Write text box as follows.
1) For the Model, enter the model ID number.
Model name
PEG-UX50/U
PEG-UX50/G
PEG-UX50/H
PEG-UX50/E
PEG-UX50/M
PEG-UX40/U
2) For the Serial, enter the serial number indicated on the rear
side of the set. (7 digits)
*
Input example
PEG-UX50/U
( )
FlashId Ver. USB
***
*
0M2 0000000
0M2 1234567
2. When the [Write] becomes active on the Flash ID dialog,
click it and check for the display of "Write completion".
4-1
* (or _UX40U)\FlashIDUSB\
Model ID number
0M2
0M3
0M4
0M5
0M6
0Q2
Confidential