Uprights And End Caps; Figure 5-2 Uprights And End Caps - GE Giraffe Service Manual

Chapter 5: Repair Procedures

5.3 Uprights and End Caps

Refer to "Figure 5-2 Uprights and End Caps".
1. Slide the decorative strip up about 1/2" in the groove on the outside of the upright to access hardware that
secures the lower end cap. You may wish to use a piece of tape to grip the strip. Use a 2.5 mm hex key to
remove the screw, then remove the bottom cap. Slide the decorative strip down to access the two screws
that secure the upper end cap, then remove the top end cap.
2. Using a 2mm hex key, remove the 4 button head socket screws and split ring washers that secure the back
cover to the display module and remove the cover.
3. Remove the 2 screws that secure the hood latch receptacle to the upright and remove the receptacle.
4. Using a 2mm hex key, remove the screw that secures the wire cover to the side of the upright.
5. To remove the wire cover, slide the wire cover up about ½", and then pull it straight back by grasping its
back edge.
68
Upright
Mounting studs
Bracket casting

Figure 5-2 Uprights and End Caps

6600-0356-000 103
Top end cap
Ground wire
Decorative strip
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Upright
Bottom end cap