Removing The Main Cover; Main Cover Tab - Toshiba 1NR Hardware Service Manual

Removing the main cover

Figure 17. Main cover tab
Follow these steps to remove the main cover:
1. Remove the top cover (see "Removing the top cover" on page 53).
2. Press the paper door assembly down until it closes and latches. You will hear a
3. Turn the printer over with the bottom of the printer facing up and locate the main
4. Turn the printer over with the paper door assembly facing up.
5. From the rear of the printer place a fingertip against the inside wall of the cover.
6. Slide your fingertip up the inside of the cover until you come in contact with the
7. Grasp the front of the printer with your opposite hand.
8. Place the thumb of your hand at the rear of the printer against the raised part of
9. Press the release tab toward the front of the printer, while pushing the rear of
To replace the main cover:
click when the paper door is closed.
cover release tab.
release tab. The release tab will be touching your fingernail.
Note: You might hear a click when you place your fingertip between the cover
and the release tab.
the printer cover.
the cover up with your thumb and lifting slightly on the front. As the cover is
released and begins to move upward, remove your hand from under the printer
and lift the cover up and off.
Note: You might have to rock the main cover back and forth slightly to get it
free of the printer unit.
Removing and replacing FRUs

Main cover tab

Chapter 5. Removing and replacing FRUs
55