Table of Contents
Advertisement
3.3
3.3.1
Siemens AB
Security Products
Omnis configuration
The Omnis communication with the Bewator Entro and the Aperio™ is done via the
BAPSI protocol. This uses the Local Area Network for sending/receiving messages
to/from the Bewator Entro system.
It is important to note down the name of the actual SR35iA Aperio Controller used in
the Bewator Entro system as it is used in the setup of the Omnis.
Please refer to the standard Omnis documentation on how to configure the BAPSI in
Omnis to link to the external system.
Omnis special notes when using Aperio™ doors
Name:
Must be 100% compatible between Omnis and Bewator Entro.
Card number:
Default in Omnis is 16 digits. Default in Bewator Entro is 8 digits. Needs to be set to
same number of digits in both systems. If not there will for example be problem with
the event log (8-digit in Bewator Entro and 16-digit in Omnis and a valid card in
Bewator Entro will generate "unknown card" in Omnis).
Access group/ Personal door:
Total number of Access group and Personal door on "Person" form in Omnis is 8 and
for Bewator Entro it is 6. If user enters 8 Access groups/Personal door, the last two is
not entered into Bewator Entro and will not work. Maximum number of Access
group/Personal door is 6 for Omnis with Aperio.
Access Group:
The Access group is created and edited in Bewator Entro (which door to access - and
when). Shown in Omnis as name (and not possible to edit). In Omnis it is possible to
give a Person access to Access groups.
Door:
The Door is created and edited in Bewator Entro (security levels on doors). Shown in
Omnis as name (not possible to edit). In Omnis it is possible to give a Person access
to Doors.
Time schedules:
Time schedules used in Bewator Entro (Access groups and Aperio Doors) is created
and edited in Bewator Entro.
Event/Log:
Personal and system event generated in Entro is transferred to Omnis.
Offline card:
It is possible to program the Aperio reader with up to 10 cards/codes that will work
when the readers gets offline (no communication between SR35iA Aperio Controller
and the Aperio Hub). These 10 card/codes is configured via the ASSA Aperio™ PAP
configuration tool, which is the same tool used for setting up the Aperio wireless
network.
3 Configuration
10
2015-05-05
Advertisement
Table of Contents
