Miele@home / Con@ctivity
If you want
– To sign the hob on to the
Miele@home system, first prepare
the signing on procedure on the
master appliance.
– To sign the hob on to Con@ctivity,
you must first sign the cooker hood
on.
To access programming mode
With the hob switched off, touch
the and sensors at the same
time until the symbol and
appear in the timer display.
After a few seconds : (Programme
01) will flash alternately with :
(Code) in the timer display.
Signing on the hob
While : is visible in the display,
touch the sensor repeatedly
until : (Programme P:10) appears.
: appears in the display.
Touch the sensor repeatedly
until : appears in the display.
The signing on process will begin and a
scrolling bar will appear in the display.
The signing on process takes a few
minutes. As soon as it is completed
successfully, : will light up in the
display.
If the signing on process is not
completed successfully, repeat the
process.
While : is visible in the display,
touch the sensor until the
indicators go out to save the setting.
56
Finish signing on the cooker hood/
master appliance (see the relevant
instructions).
Signing off the hob
If you want to sign the hob off from
Miele@home, first carry out the
signing off procedure on the master
appliance.
While : is visible in the display,
touch the sensor repeatedly
until : (Programme P:10) appears.
: appears in the display.
Touch the sensor repeatedly
until : appears in the display.
The signing off process will begin and a
scrolling bar will appear in the display.
The signing off process takes a few
minutes. As soon as it is completed
successfully, : will appear in the
display.
If the signing off process is not
completed successfully, repeat the
process.
While : is visible in the display,
touch the sensor until the
indicators go out to save the setting.