Table of Contents
Advertisement
• Children do not perceive the dangers
that can arise when using electrical
appliances and slicers. For this reason
never allow children to "play" with or
use this appliance without supervision.
Never leave the appliance running
when it is unattended.
• Check the mains cord from time to
time for damage. If any damage is
present have the mains cord changed
immediately.
In the event that a repair becomes nec-
essary, including replacing the mains
lead, the appliance must be returned
to the specialist dealer where it was
bought or to an authorised AEG cus-
tomer service centre. Repairs to electri-
cal appliances may only be carried out
by qualified specialists. Repairs carried
out by inexperienced persons may
cause serious injury to the user. No
responsibility can be accepted if the
appliance is used incorrectly or for the
wrong purposes.
Technical Data
Power consumption: 110 W
Mains voltage: 230 V
;
This appliance complies with the fol-
lowing EU Directives:
• 73/23/EEC dated 19.2.1973 "Low
Voltage Directive", including
Amending Directive 93/68/EEC.
• 89/336/EEC dated 3.5.1989 "EMC
Directive", including Amending
Directive 92/31/EEC.
• 89/109/EEC Foodstuffs Directive.
Positioning the Appliance
The Universal Slicer should be posi-
tioned on a level, clean and dry work
surface where the non-slip rubber feet
will ensure that the appliance is secure
and does not move. We recommend
wiping all parts with a slightly damp
cloth and then drying before using for
the first time.
Prior to Using
• Unwind the required length of con-
necting lead (L) from the cord storage
(K) under the appliance (Fig. 1).
• Check that the appliance is stable and
connect to the mains using the mains
plug.
• Applying firm pressure to the rear slid-
ing surface, push the food carriage (C)
into the guiding groove on the appli-
ance (Fig. 2).
• Slide the holder (H) onto the handle of
the food carriage (Fig. 3).
• Set the required cut thickness. To do
this, turn the slice thickness adjust-
ment knob (D) anticlockwise (Fig. 6).
The slices can be set to any thickness
between thin and approx. 22 mm. The
graduations on the slice thickness
adjustment knob do not represent mil-
limetres, but serve only as points of
reference. For safety reasons the start-
ing position (0) is designed to cover the
blade.
Switching On the Universal Slicer
Using the On/Off switch (A) it is possi-
ble to switch the appliance on and off
in two operating modes (Fig. 4):
• Pulse: press switch to position II. The
circular blade (G) will rotate for as long
as the switch stays pressed in this posi-
tion.
• To stop pulse operation: release the
switch and wait until the circular blade
has come to a complete standstill.
• Continuous (max. 5 minutes):
engage the switch in position I. The
circular blade will rotate without the
need to hold the switch down.
• To stop continuous operation: press
the switch briefly to position II and
wait until the blade has come to a
complete standstill.
Please note: after the appliance is
switched off, the circular blade contin-
ues to rotate for a short time.
g
9
Advertisement
Table of Contents
