LG PCRCUDT2 User Manual page 15

User Manual
Initial WLAN Module and Smart AC Connection
(Continued)
4. The Register New Air Conditioner screen will display.
• Before tapping "Continue" you will have to set the registration
mode.
5. Point the remote control at the indoor
unit, and press the Jet Mode and Fan
Speed buttons simultaneously for 3
seconds.
6. Wait for the WLAN light to blink at the
indoor unit (this may take a couple of
minutes after the beep).
• If the WLAN light does not start to blink after three minutes,
reset the registration mode again, using the remote controller,
as in step 5.
Check the WLAN light once more. If the above pairing process has not been
successful, follow the instruction below:
• Turn off the indoor unit, wait 10 seconds and then turn the indoor unit
back on (power up). Then try the above registration steps after waiting three
minutes.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Remote Controller may appear slightly
different, depending on your model.
15