Download Print this page

Federal Communications Commission - Panasonic CF-19 Series Supplementary Instructions

Hsdpa/utms modem
Hide thumbs Also See for CF-19 Series:

Advertisement

Some networks require that a valid SIM card be properly inserted in Personal Computer or
Handheld Computer incorporating WWAN.
For U.S.A.

Federal Communications Commission

R a d i o F r e q u e n c y I n t e r f e r e n c e
Statement
Note: This equipment has been tested and found
to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protec-
tion against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the instruc-
tions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular in-
stallation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equip-
ment and receiver.
Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver is
connected.
Consult the Panasonic Service Center or an
experienced radio/TV technician for help.
Warning
To assure continued compliance, use only
shielded interface cables when connecting to
a computer or peripheral. Also, any changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate this equipment.
FCC RF Exposure Warning:
This equipment is provided with PC Card slot
that could be used with wireless transmitters,
which will be specifically recommended when
they become available.
been RF exposure evaluated for use with this
computer and may not comply with FCC RF
exposure requirements.
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment.
This equipment has been approved for por-
table operation, and if provided with WWAN
transmitter, requires LCD side panel spacers
to provide minimum 1.5 cm spacing between
antenna located within the LCD side panel,
and all person's body (excluding extremities of
hands, wrist and feet) during wireless modes
of operation.
This equipment may use multiple installed
transmitters, which may be capable of simulta-
neous transmission.
This equipment is provided with external anten-
na connector(s) for connection to optional Car
Mounter or Port Replicator for mobile external
mounted antenna(s). External antenna(s) must
be professionally installed and cannot exceed
recommended maximum antenna gain as
described in individual provided supplement
instructions for wireless transmitters. Also,
user must maintain minimum 20 cm spacing
between external antenna(s) and all person'
s body (excluding extremities of hands, wrist
and feet) during wireless modes of operation.
25-M-1-1
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interfer-
ence, and
(2) This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
Responsible Party:
Panasonic Corporation of North Ameri-
ca
27-E-1-1
3

Advertisement

loading