Setting Up Inputs/Outputs; Selecting Error Handling - GE DigitalFlow GC868 Programming Manual

Setting Up Inputs/
Outputs

Selecting Error Handling

Programming Site Data
Set up the GC868's inputs and outputs via the four options in the
submenu. While following the programming instructions, refer to
Figure A-2 on page A-2 of Appendix A, Menu Maps.
• ERROR
- program the meter's response during an error condition
•
OPTN Slot 0
- set up the
• ZERO
- set the meter's zero point cutoff value
•
T,P
- set up the temperature and pressure inputs
I/O
Enter the submenu by pressing
[F1]-[F4]
screen. Then press
Note: In this section, a slot's number will appear on the option bar
only if an option card is installed in that slot. The generic
Slot x
designations
expansion slots and the function key used to select it.
Proceed to the appropriate section to program the option selection
made at the above prompt. Remember to record all programmed data
in Appendix B, Data Records.
This menu option permits programming of the manner in which the
Model GC868's totalizers respond during an error condition. See
Chapter 2, Error Codes and Screen Messages, of the Service Manual
for a discussion of the built-in error codes.
1. At the I/O prompt, press [F1] = Error.
[F1]
2. Press if you want the GC868 to Hold the last "good" reading
and continues to totalize, based on that reading, or press
if you want the meter to stop totalizing.
No Up,
analog outputs and any option cards
[F4]
at the initial User Program
I/O
to select the desired
Fx
and are used to indicate any one of the
April 2008
I/O
option.
[F2],
1-17