Basic Operation; Unit Description; Front View; Rear View - Pioneer GEX-2850DVB2 Operation Manual

Basic Operation

Unit Description

Front View

(5) Antenna In
(4) AV Out
(1) Power/IR In: A harness for connection with IR sensor and
+12V vehicle power supply.
(2) RGB Port: This is a 26-pin connector port for exclusive
connection with Pioneer AV head units (MULTIMEDIA
RECEIVER)
(3) HDMI Out: The TV audio and video output (digital) via a
mini HDMI port
(4) AV Out: The TV audio and video output (analog) via a
3.5mm earphone jack
(5) Antenna In: Antenna input connector. Note that +5V DC
output for powering active antenna is also provided via this
port.
(3) HDMI Out
(1) Power/IR In
(2) RGB Port

Rear View

(8) Operating LED (7) USB Port
(6) Video Out: The DVB-T2 TV video output via a RCA
connector
(7) USB Port: USB memory stick (or HDD) for multimedia
playback and TV recording.
Operating LED: "ON" indicates the system is working.
(8)
*Please see next chapter for more information
Note: Connect antennas to the unit BEFORE turning on engine.
Please connect the antennas first and then turn on the unit. If users turn
on the main unit and then connect the antennas later, the connected
antenna will NOT be detected nor activated for receiving DVB-T signal
as it should.
Warning: Make sure the power supply wire is correctly connected.
If this unit intends to use +12 power supply provided by vehicle via ACC wiring,
please make sure that the red wire is correctly connected with the ACC ignition
for proper system operations.
4
(6) Video Out