Cisco TelePresence System EX60 & EX90
Multipoint mode
Your video system may be equipped with the optional
ability to call more than one at a time (video conferencing).
There are basically two modes of video conferencing;
viz. MultiWay and MultiSite, see "Video conferencing—
calling more than one (optional)" on page 14 for
more on this.
Note the following:
•
To enable MultiWay, a MultiWay address must
have been entered.
•
If a MultiWay address has been specified and
MultiWay is selected, MultiWay will always be
used for video conferencing
•
If a MultiWay address has been specified, but
MultiSite is selected, MultiSite will be used.
•
If set to Auto, MultiWay will be used if a MultiWay
address has been specified, otherwise MultiSite
will be used.
•
If set to Off, no video conferencing will be
possible.
•
Any use of the MultiSite feature requires the
presence of the MultiSite option.
D1501606 User guide EX60 & EX90, English
All contents are copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. Version TC6.2, 07.2013
Settings > Administrator Settings > Multipoint Mode
This menu is inside the Administrator Settings.
Tap Back to leave the Administrator Settings
46
and tap Exit to leave all settings.
User guide
www.cisco.com