Redeye Reduction; Remaining Set; Flash Level; Sub-T Date - Sony Handycam DCR-DVD510E Operating Manual

REMAINING SET

B ON
Always displays the remaining media
capacity indicator.
AUTO
Displays the remaining recording time of
movie for about 8 seconds in the following
situations.
– When your camcorder recognizes the
remaining media capacity when the
POWER switch is set to
– When you press DISP/BATT INFO to
switch the indicator from off to on when
the POWER switch is set to
– When you select the movie recording
mode on the HOME MENU.
b Notes
• When the remaining recordable time for movies
is less than 5 minutes, the indicator stays on the
screen.

SUB-T DATE

You can display the recording date and time
when playing back a disc on a device with a
subtitle display function. The default setting
is [ON].
Also refer to the instruction manual of the
playback device.
b Notes
• You cannot set [SUB-T DATE] for a "Memory
Stick PRO Duo."

FLASH MODE

You can set this function when you record
still images using the built-in flash, or an
external flash (optional) that is compatible
with your camcorder.
B AUTO
Automatically flashes when there is
insufficient ambient light.
ON ( )
Always flashes regardless of the
surrounding brightness.
OFF (
Records without flash.
b Notes
• The recommended distance to the subject when
using the built-in flash is approximately 0.3 to
2.5 m (1 to 8 feet).
• Remove any dust from the surface of the flash
lamp before using it. Flash effect may be
(Movie).
impaired if heat discoloration or dust obscures
the lamp.
• /CHG lamp (p. 122) flickers while charging
(Movie).
the flash, and remains lit when charging is
complete.
• If you use the flash when shooting a backlit
subject or in bright places, the flash may not be
effective.

FLASH LEVEL

You can set this function when you record
still images using the built-in flash, or an
external flash (optional) that is compatible
with your camcorder.
HIGH(
Makes the flash level higher.
B NORMAL( )
LOW(
Makes the flash level lower.
REDEYE REDUC

(Redeye reduction)

You can set this function when you record
still images using the built-in flash, or an
external flash (optional) that is compatible
with your camcorder. If you set [FLASH
MODE] (p. 75) to [AUTO] or [ON] when
[REDEYE REDUC] is set to [ON],
appears on the screen. You can prevent
redeye by activating the pre-flash before
recording.
)
)
)
Continued ,
75