Disassembly For Repair - Kenwood NX-200 Service Manual

NX-200(G)
Voice Guide & Storage Unit (VGS-1: Option)
■ Installing the VGS-1
1
. Attach the flat spring (G02-1846-03) to the VGS-1 as
shown in the fi gure.
Note:
Attach the fl at spring so that its convex fi ts the PCB hol-
low of the VGS-1.
2. Attach the cushion (G13-1974-04) to the VGS-1 as shown
in the fi gure.
Note:
Be sure to not cover the VGS-1 connector with the cush-
ion.
3. Insert the VGS-1 connector into the connector (CN710) of
the Control PCB.
4. Reinstall the cover using the two screws removed in step
1 of "Removing the GPS PCB" described on page 6.
1. Precautions for Waterproof
• Do not remove the black sheet from the reverse side of
the transceiver (refer to the illustration right). Removal
of this sheet decreases the waterproof effi ciency of the
transceiver and may cause malfunctions if water seeps
into the transceiver.
• The orange packing material on the reverse side of the
transceiver is important with respect to the waterproof ef-
fi ciency of the transceiver. Do not place stickers or other
materials on or around the packing material shown in the
fi gure, or on the reverse side of the battery pack. Doing
so will impair the waterproof effi ciency of the transceiver
and may cause it to break down. Additionally, in order to
prevent damage to the packing material, do not allow it to
come in contact with foreign materials.
8
INSTALLATION
The coaxial cable is located under the GPS PCB.

DISASSEMBLY FOR REPAIR

VGS-1
CN710
VGS-1
PCB hollow
Flat spring
(G02-1846-03)
Convex part
Cushion
(G13-1974-04)
21x21x1.0mm
Flat spring
VGS-1
Cushion