Playing Back Cpl; Calling Up Screen Adjustment Data; Selecting A Cpl - Sony SRX-R815P Operating Instructions Manual

Playing Back CPL

Calling up Screen Adjustment Data

Depending on the content's signal classification (2D/3D,
viewing angle (HD/scope/flat)) for playback, screen
adjustment data can be called up when registered in the
function memory. Settings such as 2D/3D mode, zoom
ratio, and brightness are recorded in the adjustment data.
For details on the function memory or adjustment data,
refer to the "Installation Manual."
1
In the [Status] tab, tap [Auditorium], and then tap
[Projector] in the [Control] pane.
The "Projector Control" screen appears.
2
Select the adjustment data appropriate to the content
from the [Function] list, and then tap [Load].
The adjustment data will be loaded into the projector.
3
Tap [CLOSE] at the bottom of the screen to close the
screen.
Tip
It is necessary to have a 2D lens mounted on the projector,
and for screening of 3D content, it is necessary to have a
3D lens mounted on the projector. Showing of 2D content
is possible with either a 2D or 3D lens.
The lens mounted on the projector can be checked in the
"Status" tab's "Auditorium" screen.
For details on how to change the lens, see "Attaching and
Removing the Lens" (page 31), and "Replacing the Lens
Using the Lens Change Table" (page 34).
Procedures for fine-tuning adjustment data
The following operations are available for each button in
the "Projector Control" screen.
[Light Power]: You can adjust the screen brightness
[Zoom]: Adjusts the screen size (for 2D lenses only)
[Focus]: Adjusts the screen focus (for 2D lenses only)
[H]: Adjusts the horizontal position of the screen (for 2D
lenses only)
[V]: Adjusts the vertical position of the screen (for 2D
lenses only)
Caution
Be aware that when you tap [Save], the fine-tuned
adjustment data will overwrite the setting values of the
function number selected in the [Function] list.

Selecting a CPL

Tips
• When in Schedule Playback mode, tap [Scheduled] or
[Manual] (the display will change) to set to Manual
mode, or select the [Play Manually] check box. [Play
Manually] is convenient for temporary playback of tests
while in Schedule Playback mode.
• When [Play Manually] is selected and the manual
playback and scheduled playback overlap, the content
played back last will take priority.
21
Information based on Function settings
currently loaded will be displayed.