Important Safety Instructions - DeWalt DCR010 Instruction Manual

English

IMPORTANT SAFETY INSTRUCTIONS


WARNING:
a ) Read these instructions.
b ) Keep these instructions.
c ) Heed all warnings.
d ) Follow all instructions.
e ) Do not use this apparatus near water.
f ) Clean only with a dry cloth.
g ) Do not block any ventilation openings.
accordance with the manufacturer's instructions.
h ) Do not use near any heat sources such as radiators,
heat registers, stoves or other apparatus (including
amplifiers) that produce heat.
i ) Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
j ) Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
k ) Only use attachments/accessories specified by
the manufacturer.
l ) Unplug this apparatus during lightning storms or
when unused for long periods of time.
m ) Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
n ) Apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
o ) Do not use under wet conditions or in presence of
flammable liquids or gases.
p ) Do not keep ears close to this appliance.
Safety Instructions for Speakers
• To reduce the risk of fire or electric shock, do not expose
this apparatus to rain or moisture.
• Do not abuse cord. Never carry the speaker by its cord.
Never pull the cord to disconnect from the socket. Keep the
cord away from heat, oil and sharp edges.
• Remove the battery pack. Switch off before leaving
it unattended. Remove the battery pack when not in
use, before changing accessories or attachments and
before servicing.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
2
use of the appliance by a person responsible for their
safety.
• Children should be supervised to ensure that they do not
play with the appliance.
• No exposed flame sources, such as lighted candles, should
be placed on the speaker.
• To reduce the risk of hearing damage, do not place ears
too close to the speaker.
• Mains plug is used as the disconnect device; the
disconnect device (plug) shall remain readily operable.
Use in
• An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety. The smaller
the gauge number of the wire, the greater the capacity
of the cable, that is, 16 gauge has more capacity than 18
gauge. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. When using
more than one extension to make up the total length,
be sure each individual extension contains at least the
minimum wire size. The following table shows the correct
size to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier gauge. The
lower the gauge number, the heavier the cord.
Volts
120 V
240 V
Ampere Rating
More
Than
0
6
10
12
The label on
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
sfpm ................... surface feet per
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
Minimum gauge for Cord sets
Total length of Cord in Feet
(meters)
25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7)
50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
not
American Wire gauge
More
Than
6 18 16
10 18 16
12 16 16
16 14 12
this unit may include the following symbols.
...................... Class II
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
(grounded)
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
..................... wear eye
minute
..................... wear hearing
minute
..................... read all
direct current
16 14
14 12
14 12
Not Recommended
The
Construction
(double insulated)
protection
protection
protection
documentation