Changing A Lamp - Miele DA 1255 Operating And Installation Instructions

Changing a lamp

The lamps should be replaced with a
lamp of the same type:
Manufacturer ............................... EGLO
Lamp type .................................... GU10
Specification................................ 11427
Wattage ........................................... 3 W
ILCOS D Code...... DR-3-H-GU10-50/56
Alternatively the following lamps can be
used:
Manufacturer ............................... EGLO
Lamp type .................................... GU10
Specification................................ 11511
Wattage ........................................... 5 W
ILCOS D Code...... DR-5-H-GU10-50/54
These lamps have a different luminosity.
Only use lamps of the same type in the
cooker hood.
These lamps are available from Miele or
from specialist retailers.
 Switch off the fan and the lighting.
 Remove the grease filters.
 Disconnect the cooker hood from the
mains electrical supply (see "Warning
and Safety instructions").

The lamps can get hot in use.
Allow the lamps to cool down for a
few minutes before changing them.
Cleaning and care
 Loosen the halogen lamp's securing
screw a little.
 Slide the screw and the lamp
downwards.
 Then tighten the screw again.
 Turn the lamp anti-clockwise and pull
it out.
 Screw the new lamp into the socket.
Please follow the manufacturer's
safety instructions.
 Slightly loosen the screw again, push
the lamp upwards, and tighten the
screw.
 Replace the grease filters.
23