D-Link COVR-3902 Faqs page 105

Step 2: Connect a cable from a LAN port (1,2,3,4) on your Primary Router to a LAN port (1,2,3,4) on your
new router.
Connect with LAN ports (Do not connect WAN port)
The setup is now complete. If you now want to configure the wireless settings on your "new" router, go to
.
this address: http://192.168.0.2
Note: NAT, defined in RFC 3022, allows a host that does not have a valid, registered, globally
unique IP address to communicate with other hosts through the Internet. The hosts might be using
private addresses or addresses assigned to another organization. In either case, NAT allows these
addresses that are not Internet-ready to continue to be used and still allows communication with hosts
across the Internet.
104