Preparing A Power Source - Sony MZ-M200 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual

Preparing a Power
Source
Charge the rechargeable battery before using
it for the first time or when it is depleted.
Operations can be done on the recorder or the
remote while charging.
1
Slide and open the battery
compartment lid in the direction of
the arrow.
2
Insert the rechargeable battery.
Insert it starting with the
terminal end.
Insert the battery with
the label side facing up.
3
Close the lid.
14
 
and
4
Connect the AC power cord and the
USB cable to the AC power adaptor.
USB cable
AC power adaptor
5
Connect the other end of the USB
cable to the recorder and the AC
power cord to a wall outlet.
Recorder
To the USB cable
connecting jack
6
Confirm that charging has started.
When charging starts,
charging time ("Charging --min left")
appear at the start of charging. When the
charging time disappears, charging ends
once and the battery becomes sufficiently
charged. A completely depleted battery
takes about one hour to reach this point,
at which time it is approximately 80%
charged. For a 100% charge, an additional
2 hours of charging is needed.
If the charging time indication disappears
after a short time, this means the battery is
sufficiently charged.
AC power cord
To a wall
outlet
and the