Sanyo DP26670 Service Manual page 23

2.4: SPRING SHUTTER/PLATE RETAINER/
RETAINER SHUTTER/COVER CLAMPER/
PLATE CLAMPER/MAGNET CLAMPER/
CLAMPER/GUIDE DISC/LEVER DISC/
SPRING LEVER GUIDE/SPRING LEVER DISC/
LEVER DISC (Refer to Fig. 2-4-A)
1. Unlock the support (1).
2. Remove the Retainer Shutter Ass'y.
3. Remove the Spring Shutter.
4. Remove the 3 screws (2).
5. Remove the Plate Retainer.
6. Remove the Retainer Shutter.
7. Unlock the 2 supports (3).
8. Remove the Cover Clamper.
9. Unlock the 3 supports (4).
10. Remove the Plate Clamper.
11. Remove the Magnet Clamper.
12. Remove the Clamper.
13. Unlock the support (5).
14. Remove the Guide Disc.
15. Remove the Lever Guide.
16. Remove the Spring Lever Guide.
17. Remove the Spring Lever Disc.
18. Remove the Lever Disc.
Spring Shutter
Retainer Shutter
(2)
(2)
(2)
Plate Retainer
(3)
Clamper
(4)
Magnet Clamper
Plate Clamper
Cover Clamper
• Screw Torque: 0.7 ± 0.3kgf•cm (Screw (2))
NOTE
1. In case of the Retainer Shutter Ass'y installation,
check if the value of the Fig. 2-4-B is correct.
2. In case of the Clamper Ass'y installation,
check if the value of the Fig. 2-4-C is correct.
DISASSEMBLY INSTRUCTIONS
Guide Disc
(5)
Frame Mian
Spring Lever Guide
(1)
Lever Guide
Lever Disc
Spring Lever Disc
Fig. 2-4-A
Spring Shutter (2pcs)
Retainer Shutter
(OK)
Clamper Ass'y
2-5: FFC WIRE HANDLING
1. When installing the FFC, fold it correctly and install it as
shown from Fig. 2-5-A to Fig. 2-5-D.
NOTE
1. Do not make the folding lines except the specified
positions for the FFC.
[ 22 pin FFC ]
Printing Surface
B2-4 B2-4
Check Hook
Frame Main Ass'y
(NG)
Fig. 2-4-B
Check Hook
Fig. 2-4-C
35 ± 1mm
Fold
Fig. 2-5-A