KV-21LT1
2-1. Rear Cover Removal
=>
=>
Release the mains power cable from its securing posts.
Remove the rear cover fixing screws indicated. Pull the rear
cover away from the front beznet until clear of chassis.
Note : Use a cross-head screwdriver with a blade length of at
least 200mm.
2-3. A Board PWB Removal [ Step 2 ]
Release the 2 securing
clips located at either
side of the chassis and
slide the PWB clear of
the bracket.
2-4. Service Position
Place the A Board PWB in the
position indicated to carry out
servicing.
SECTION 2
DISASSEMBLY
2-2. A Board PWB Removal [ Step 1 ]
<=
<=
Remove FBT
support bracket.
2-5. Wire Dressing
Ensure that all wires do not touch heat-sinks and high
temperature hot spots. All wires must be kept at a minimum
distance of 20mm away from the EHT lead.
12
Remove screw.