Operating The Cutting Tool On A Horizontal Edge (Top/Down) - ABB SPACOM 100 Operating Manual

6 R E L AY R E T R O F I T P R O G R A M C U T T I N G T O O L O P E R AT I N G G U I D E S PA C O M 1 0 0
—
4. Operating the cutting tool on
a horizontal edge (top/down)
4.1
4.2
4.3
To cut horizontally, place the cutting head guiding
against the top or bottom edge of the opening.
Ensure that the cutting head is set in the correct
position. The text HORIZONTAL Up and Down must
point in the direction you are cutting.
For your safety, keep your hands on the power unit,
never on the cutting head.
Beware of the sharp edges!
Remove the offcut from the cutting head after each
cutting cycle.