Table of Contents
Advertisement
128.7 122.5
All measures in millimeters
9.4 The CMX-RM Rack Mount
This accessory is a plastic box that can house up to four CMX boards of any model. The CMX-RM is composed of the
box body that is hinged to the box back and by a serigraphed aluminium front panel. Moreover, to properly mount the
CMX you need as many CMX-BP backplanes as CMXs you wish to mount.
To let the box body rotate around the hinges, put the slit of the hinge screw in horizontal position, pull down the hinge
in order to free the pivot and then rotate the box. To tighten the box again, repeat the operations in the inverse order.
To mount the CMX-RM, you have to make a hole in the box back for the cables and then to mount it on the wall. Then
connect the cables to the backplane connector. Remember that the screw part of the connectors is detachable. Insert
the connectors in their place, rotate the box body at its place around the hinges and tighten it. Insert the CMX boards
and mount the front panel.
E1110A.DOC
224.5
Fig. 9.6
Fig. 9.7
Data and design subject to change without notice. Supply subject to availability
© Copyright by CERBERUS AG, CH-8708 Männedorf, Switzerland 1995
ACCESSORIES
68
45.7
126
115
01.96
136
37[51]
Advertisement
Table of Contents
