Page 2
Showline. Its sole purpose is to provide the user with conceptual information on the equipment mentioned. The use of this document for all other purposes is specifically prohibited. SL eSTROBE 130 User’s Manual 24-004-3590-00 Rev1.0 SL eSTROBE 130 LED Luminaire installation & User’s Manual 2013 Philips Group. All rights reserved.
Installation & User’s Manual SL eSTROBE 130 LED Luminaire Warnings and Notices When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Do not use outdoors. Do not mount near gas or electric heaters. Equipment should be mounted in locations and at heights where it will not readily be subject to tampering by unauthorized personnel.
Installation & User’s Manual SL eSTROBE 130 LED Luminaire TABLE OF CONTENTS Showline Offices Inside Front Cover IMPORTANT INFORMATION Warnings and Notices Additional Resources for DMX512 Showline Limited Two-Year Warranty TABLE OF CONTENTS PREFACE About this Manual Included Items SL eSTROBE 130 LED LUMINAIRE OVERVIEW SL eSTROBE 130 LED Luminaire Components Common Luminaire Components LCD Display / Menu System...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire PREFACE About this Manual The document provides installation and operation instructions for the following products: SL eSTROBE 130 LED Luminaire Please read all instructions before installing or using this product. Retain this manual for future reference. Additional product information and descriptions may be found on the product specification sheet.
Installation & User’s Manual SL eSTROBE 130 LED Luminaire SL eSTROBE 130 LED Luminaire Overview SL eSTROBE 130 LED Luminaire Components Common Luminaire Components Front of Unit Rear of Unit DMX512-A / DMX512-A / RDM Input RDM THRU Yoke Assembly LCD Display / AC Power Input Menu System...
SL eSTROBE 130 LED Luminaire Installation & User’s Manual LCD Display / Menu System LCD Display ENTER(OK) Button EXIT Button LEFT Arrow Button RIGHT Arrow Button Figure 2: LCD Display & Menu System "LCD Display and Menu System” on page 8. Note: For Menu operation and programming details, refer to the LCD Display/Menu System...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire INSTALLATION AND SET UP Power Requirements The SL eSTROBE 130 LED Luminaire operates on AC input voltages from 100 to 240 VAC. WARNING! This luminaire does not contain an ON/OFF switch. Always disconnect power input cable to completely remove power from the luminaire when not in use.
SL eSTROBE 130 LED Luminaire Installation & User’s Manual "Additional Resources for DMX512" on Note: For more information on DMX512 networking and systems, refer to "DMX CONTROL" on page 13. page 1. For SL eSTROBE 130 LED Luminaire DMX Mapping, refer to DMX512 Connections DMX512 Signal XLR Pin...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire OPERATION AND PROGRAMMING 1. LCD Display and Menu System SL eSTROBE 130 LED Luminaires The SL eSTROBE 130 LED Luminaire’s LCD Display and Menu System provides local control for accessing the following fixture’s settings: Presets (Standard and User Defined) Chase...
Page 11
SL eSTROBE 130 LED Luminaire Installation & User’s Manual Preset To edit and save a preset Main Menu 1. Preset Press the OK button to access the Preset menu. Use the LEFT and RIGHT arrow buttons to scroll through all presets and select the desired preset number.
Installation & User’s Manual SL eSTROBE 130 LED Luminaire 3. SL eSTROBE 130 LED Luminaire Menu Tree Figure 8: SL eSTROBE 130 LED Luminaire Menu Tree SL eSTROBE 130 LED Luminaire Menu Tree...
PL_Curve S_Curve Square Curve Linear Curve PL_Curve DMX Value DMX Value *PL Curve follows the dimming curve of Philips Selecon PL series LED luminaires. S_Curve Square Curve DMX Value DMX Value Figure 9: SL eSTROBE 130 LED Luminaire Dimmer Curves...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire The Master / Slave Operational Mode allows one SL eSTROBE 130 LED Luminaire to act as the “Master” luminaire all other connected luminaire s are controlled by this master luminaire. When a luminaire is set to “Slave”...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire This section contains information for operating the luminaire using DMX control in Single Channel, Three Channel, Four Channel, 16-Bit Control or Zone Mapping modes. For Menu options and detailed information, see the “LCD Display and Menu System”...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire Four Channel Mode Table 4 provides DMX channel mapping of all DMX512 control values when the SL eSTROBE 130 LED Luminaire is in Four Channel mode (as set by the luminaire’s menu system). Table 4: SL eSTROBE 130 LED Luminaire DMX Channel Mapping (Four Channel Mode) Default- recommended Range DMX...
SL eSTROBE 130 LED Luminaire Installation & User’s Manual 16-Bit Mode Table 5 provides DMX channel mapping of all DMX512 control values when the SL eSTROBE 130 LED Luminaire is in 16-Bit mode (as set by the luminaire’s menu system). Table 5: SL eSTROBE 130 LED Luminaire DMX Channel Mapping (16-Bit Mode) Default- recommended Range DMX...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire Zone Mapping Mode Table 6 provides DMX channel mapping of all DMX512 control values when the SL eSTROBE 130 LED Luminaire is in Zone Mapping mode (as set by the luminaire’s menu system). Table 6: SL eSTROBE 130 LED Luminaire DMX Channel Mapping (Zone Mapping Mode) Default Range DMX...
Page 28
Installation & User’s Manual SL eSTROBE 130 LED Luminaire Table 8: SL eSTROBE 130 LED Luminaire Strobe Duration SL eSTROBE 130 LED Luminaire Strobe Duration...
Page 29
SL eSTROBE 130 LED Luminaire Installation & User’s Manual Table 8: SL eSTROBE 130 LED Luminaire Strobe Duration Note: White light mode ( when strobe rate is also at 255) Strobe Duration...
Table 9: SL eSTROBE 130 LED Luminaire RDM Product Parameters IDs Product Category Model ID Manufacturer Model Description 0x2018 0x0509 Philips Entertainment. Lighting Asia SL eSTROBE 130 Table 10: SL eSTROBE 130 LED Luminaire RDM UID MSB of ESTA LSB of ESTA MSB of LSB of...
Installation & User’s Manual SL eSTROBE 130 LED Luminaire WARNING!All cleaning should be performed with power completely removed from the luminaire. Never remove protective covers when the luminaire is powered. Wear appropriate protective eye wear and gloves when cleaning the luminaire. All service and maintenance, other than described herein, should be performed by a qualified technician or Authorized Service Center.
Installation & User’s Manual SL eSTROBE 130 LED Luminaire Disassembly (other than as described herein), alterations, unauthorized service, etc. will void the product warranty. Contact your local Showline office or an Authorized Service Center for technical support and service. Accessories Only Showline approved accessories should be used with your SL eSTROBE 130 LED Luminaire.