Toro Sand Pro 3040 Installation Instructions page 3

Maintenance
Greasing the Attachment
If the locking lever on the attachment adapter does not
pivot freely and easily, apply a light coat of grease to the
area shown in figure 4.
Figure 4
Adjusting the Actuating Rod Springs
The springs and actuating rods are adjusted at the factory.
However, if new parts are installed or the springs are
removed for any reason, the spring length should be
adjusted to 5.24 inches (Fig. 5)
Figure 5
5.24"
Leveling the Finish Grader Blade
To level the blade in relation to the traction unit, place the
unit on a level surface (such as a concrete driveway), and
slightly vary the rear tire pressure as required.
Reversing the Scraper Blade
The scraper blade (Fig. 6) can be reversed for a second
wear surface after the original edge has worn beyond
acceptable limits.
1
Figure 6
1. Scraper blade
Optional Equipment
Weeder Tooth Scarifier
Carbide Tipped Tooth Scarifier
(15 required for each)
3
Part No. 112–0260–03
Part No. 110–0260–03