Sony DSR-45/45P Operating Instructions Manual page 47

• When the COUNTER SELECT selector on the front
panel of this unit is set to COUNTER, the value
determined by calculation based on the time code is
displayed. The value is a simple approximation.
Therefore, if you intend to use this unit as a player in
the editing system, set the COUNTER SELECT
selector to TC and also set the edit mode (EDIT
REFERENCE) of the editing controller to time code
(TC).
Settings on editing controller
When connecting an editing controller, make the
following settings, according to the model used.
FXE-100/120
Set the VCR device constants as follows:
1 2 3 4 5 6 7
80 31 00 96 05 05 0A 8A 0A 08 FE 00 80 5A FF
FXE-100P/120P
Set the VCR device constants as follows:
1 2 3 4 5 6 7
81 31 00 7D 05 05 0A 8A 0A 08 FE 00 80 5A FF
BVE-600/2000 (NTSC model)
Set the VCR device constants as follows:
1 2 3 4 5 6 7
80 31 00 96 05 05 0A 8A 0A 08 FE 00 80 5A FF
BVE-600/2000 (PAL model)
Set the VCR device constants as follows:
1 2 3 4 5 6 7
81 31 00 7D 05 05 0A 8A 0A 08 FE 00 80 5A FF
RM-450/450CE
Set the DIP switches as follows:
Left switch
7 6 5 4 3
OFF – – OFF –
Right switch (RM-450)
7 6 5 4 3
OFF – OFF ON OFF OFF ON ON
8 9 10 11 12 13 14 15
8 9 10 11 12 13 14 15
8 9 10 11 12 13 14 15
8 9 10 11 12 13 14 15
2 1 0
– – –
2 1 0
Right switch (RM-450CE)
7 6 5 4 3
ON – OFF ON OFF OFF ON ON
If the edit timing is out of adjustment, change the
setting of items 0 to 2 of the right switch.
Chapter 3 Using the Unit as a Player in an Editing System
2 1 0
47
(GB)