Entering Totalizer Data; Entering Mass Flow Data - GE DigitalFlow GF868 Programming Manual

1.7.3 Entering Totalizer Data

10. Use the [F1]-[F4] and
11. Use the keys to select the Total Decimal Digits (the desired number of digits to the right of the decimal
[F1]-[F4]
point) in the totalized flow display.

1.7.4 Entering Mass Flow Data.

12. Use the keys to select the Mass Flow units, listed in Figure 11 on page 87.
[F1]-[F4]
13. Use the [F1]-[F4] keys to select the Mass Flow Time units.
14. Use the [F1]-[F4] keys to select the MDOT Decimal Digits (the number of digits to the right of the decimal point) for
displaying mass flow.
15. Use the [F1]-[F4] keys to select the Mass (Totalizer) units.
16. Use the to specify the Mass Decimal Digits (the number of digits to the right of the decimal point) for
[F1]-[F4]
displaying totalized mass flow. The meter returns to the initial User Program screen.
1.7.4a Procedure Options
After completing the above steps, the meter returns to the
•
To continue programming the meter, refer to the menu maps in Appendix A and navigate to the desired menu.
Then, proceed to the appropriate section of the manual for instructions.
•
To leave the User Program and retain the previous settings, press
prompt. Any programming changes will be discarded and you will be returned to the data display.
•
To leave the User Program and return to measurement mode, press
prompt. Your programming changes will be entered into the meter's memory, and you will be returned to the data
display.
DigitalFlow™ GF868 Programming Manual (1-Channel)
[ keys to select the Totalizer Units.
prompt. Continue as follows:
User PROGRAM
and then press
[EXIT]
and then press
[EXIT]
Chapter 1. Programming Site Data
at the SAVE
[F1] = NO
at the SAVE
[F2] = YES
11