Introduction; Power Supply; Installation Overview - Siemens AC5200 Quick Start Manual

1

Introduction

1.1

Power Supply

1.2

Installation Overview

Siemens AB
Security Products
The AC5200 (ACC-Lite) is a smaller alternative to the ACC (Advanced Central
Controller) used in SiPass integrated. The AC5200 is based on the Entro
SR34i/SR35i controller and exists in two variations:
AC5200: 8 Door controller with preloaded ACC Firmware.

ACC-X – An Entro Controller upgraded with ACC Firmware. The X represents

the number of doors supported.
The AC5200 can be used with either ACC or Entro devices. However ACC-X con-
trollers can only be used with Entro devices, and are for migration sites.
This Quick Start Manual outlines how to install and configure an AC5200 controller
to work with SiPass integrated.
Ensure that the power supply is stable and within the rated voltage of the unit. Use
an uninterrupted power supply (UPS) to ensure a continuous function of the unit in
the event of power dips on the mains supply.
The following is a list of items required to complete this installation:
AC5200 or Entro SR34i/SR35i Controller

12-24V power source

Ethernet cable

ACC FLN or Entro Devices + wiring

Optional items:
Modem + RS232 cable

The installation should proceed in this order:
1. Connect power to the AC5200.
2. Connect the FLN bus.
3.
Connect the Ethernet.
4. Configure the network settings.
5.
Create the AC5200 in SiPass integrated.
Introduction
5
10.2013