Product Overview; Controls; Engine Controls; Figure - Toro 22618 Operator's Manual

Product Overview

1. End plate
2. Spitting wedge
3. Jack lift
4. Hitch receiver
5. Safety chains

Figure 3

6. Rail locking pin
7. Hydraulic filter
8. Hydraulic reservoir
9. Control lever

Controls

Become familiar with all the controls before you start
the engine and operate the machine.

Engine Controls

4
3
2
1
g205930
1. Recoil-start handle
2. Fuel valve
3. Choke lever
4. Throttle lever
Fuel Valve
The fuel valve
choke lever. Move the lever for the fuel valve to the
O position before attempting to start the engine.
N
When you have finished using the machine, shut off
the engine and move the fuel-valve lever to the O
position.
Choke Lever
Use the choke lever
Before pulling the recoil-start handle, move the choke
lever to the C
LOSED
running, move the choke lever to the O
Do not use the choke if the engine is already warmed
up or if the air temperature is high.
Throttle Lever
The throttle lever
of the engine. It is located next to the choke lever.
Engine O /O
N FF
The O /O switch is located on the front of the
N FF
engine.
6
5
8
Figure 4
5. Fuel cap
6. Oil dipstick
7. Oil-drain plug
8. O /O
N FF
(Figure 4) is located underneath the
(Figure 4) to start a cold engine.
position. Once the engine is
(Figure 4) controls the speed (rpm)
Switch
6
7
G019744
g019744
switch
FF
position.
PEN