Fuel Sender Installation - Yamaha 2CMH Rigging Manual

FUEL MANAGEMENT GAUGE

FUEL SENDER INSTALLATION

Follow the notifications below.
1. Locate the sender in a well ventilated area in boat between the engine and a water separator.
2. Place the sender with the "UP" mark facing upward.
3. Use a fuel joint that is fitted to the fuel hose of the outboard motor.
4. Secure all fuel hose ends with a good quality hose clamp.
* For twin-application, refer to Wiring diagram in this chapter.
See the installation manual in the package for further information.
To extension wire lead
Pu (S)
Fuel valve
Fuel tank
To extension wire lead if water detection switch is incorporated.
B (–) Or (+)
Water separator
(Market obtainable)
IN OUT
Inboard area
Nipple1/4-18NPT
(Market obtainable)
Clamp
Fuel flow
sensor
OUT
IN
UP
5-14
Primer
bulb
Clamp