Fujitsu AUU7RLF Design & Technical Manual page 228

¢ Description of display
LED display lamp
(1) POWER/MODE
(2) ERROR
(3) MONITOR
Switch
• For the test run start and stop.
SW1 Push
• For the pump down start and stop.
• For when check run function is activated.
SW2 Push • For displaying the check run.
• For resetting the Automatic wiring correction memory.
SET1-1 DIP For selecting cooling or heating during test operation.
SET1-2 DIP For switching SW1 operation.
SET1-3 DIP (Prohibited)
SET1-4 DIP (Prohibited)
• For selecting outdoor unit low noise operation function.
SET2-1 DIP
• To use this function, the Central remote controller (option)
SET2-2 DIP (Prohibited)
SET2-3 DIP (Prohibited)
SET2-4 DIP (Prohibited)
SET3-1 DIP (Prohibited)
SET3-2 DIP (Prohibited)
SET3-3 DIP (Prohibited)
SET3-4 DIP (Prohibited)
Be sure to disconnect the power supply or turn off the breaker before changing the DIP switch
setting.
13-1. Setting methods
Green
Red
A Red
B Red
C Red
D Red
E Red
F Red
Function or operation method
is necessary.
Function or operation method
• Turns on when the power supply is ON (Including
when error occurs).
• Indicate the MODE by the number of flashes when
the installation function is active.
Flashes at high-speed when there is an error.
• Displays the location and contents of errors when
there is an error. (Refer to Chapter 14-3.
on page 232 for details.)
• Displays when check run is activated. (Refer to
Chapter 14-1. "Check run"
- 222 -
"Error code"
on page 224 for details.)
Factory setting
—
—
OFF
OFF
OFF (Do not change)
OFF (Do not change)
OFF
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
13. Function settings