Remote Command - Sony RS-232C Interface Manual

• Video signal type (17th through 22nd byte)
This command is used to set the type of video signal of the equipment connected to LINE4 A to F.
SIGNAL DEFINE
VIDEO
S VIDEO
RGB
COMPONENT
LAN
• Projector protocol (23rd byte)
This command is used to select protocol of the projector to be connected.
Bit 0 of the "PJ CONTROL" changes depending on the protocol.
PROTOCOL
VPL-FX50
VPL-PX32/31/21
PFM-42B1
VPL-PX15
VPL-PX10/PS10
VPL-CX11/CX10
SANYO LP-XP45/40
VPL-PX11
VPL-PX40/35
PFM-50C1
User define
Example: When setting the respective parameters as shown below.
LINE3 machine type
LINE3 connected channel
LINE4A-F machine type
LINE4A-F machine type
CONTROL S I/F TYPE
PJ CONTROL
LINE4 A-C signal define
LINE4 D-F signal define
Projector protocol
43[H] 4D[H] 54[H] 53[H] 37[H] 40[H] 30[H] 41[H] 30[H] 41[H] 30[H] 41[H] 30[H] 41[H] 30[H]
41[H] 30[H] 41[H] 41[H] 42[H] 30[H] 30[H] 30[H] 32[H] 32[H] 32[H] 30[H] 30[H] 0D[H]
('C S I O 7 @ 0 A 0 A 0 A 0 A 0 A 0 A A B 0 0 0 2 2 2 0 0 CR')
REMOTE PARAMETER REQUEST : 52[H] 50[H] 49[H] 4F[H] ('RPIO')
This command is used to read setups of the CONTROL S OUTPUT and PROJECTOR CONTROL from the SRP-X700P.
• Packet format
52[H] 50[H] 49[H] 4F[H] 0D[H]
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] ('A')) in the
order shown below.
41[H] "parameter" 0D[H]
The parameter is the same as the 24 byte parameter of the REMOTE command.
30[H] ('0')
31[H] ('1')
32[H] ('2')
33[H] ('3')
34[H] ('4')
PJ CONTROL
bit0
0
30[H] ('0')
0
31[H] ('1')
0
32[H] ('2')
1
33[H] ('3')
1
34[H] ('4')
1
35[H] ('5')
0
36[H] ('6')
37[H] ('7') 0
38[H] ('8') 0
39[H] ('9') 0
0
7A[H] ('z')
: CD
: 1
: NONE
: 2
: CH1 is set to IR, and CH2-4 are set to WIRED.
: REMOTE POWER ENABLE is set to ON.
: VIDEO
: RGB
: VPL-FX50
Supported firmware
version
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.00 and higher
1.20 and higher
1.20 and higher
1.20 and higher
1.10 and higher
– 53 –