Setting The Transfer Processing For Nonrecorded Sections; Copying The Timecode Recorded In The Source Cassette; Selecting The Output Audio Channel Of E-Monitor - Sony BKMW-E3000 Operation Manual

Setting the Transfer Processing for
Nonrecorded Sections
When the material transfer range is from the tape top to the
tape end (transfer of the virtual file &whole.mxf), or from
the current position to the tape end (transfer of the virtual
file &current.mxf), you can stop the transfer automatically
when a nonrecorded section is played back continuously
for a specific length of time. This setting is effective when
you do not know the length of the material but want to
transmit from a specific position to the last point where
signals are recorded.
When required, change the setting using the Setup menu
ITEM-251: NO RF TIME on the transmitting VTR.
For details on setup operation, refer to the Operation
Manual supplied with the VTR.
NO RF TIME
The setting range is from 5 sec to 30 sec. The default value
is 30 sec.
16
Preparations
ITEM-251
30 sec
Copying the Timecode Recorded in
the Source Cassette
To enable the timecode (LTC) on the source cassette in the
transmitting VTR to be recorded as-is to the cassette in the
receiving VTR, this must be set on the Setup menu ITEM-
252: TCG NETWORK REGEN MODE.
For details on setup operation, refer to the Operation
Manual supplied with the VTR.
ITEM-252
TCG NETWORK REGEN MODE
off
off (default setting): The recorded timecode is
regenerated by the timecode generator during
recording of video/audio signals transferred through
the network.
on: The timecode generator locks to the timecode of the
transmitting VTR and the timecode on the source tape
is copied as-is during recording of video/audio signals
transferred through the network.
Notes
• When recording signals through an interface external to
the network to which the VTR is connected, the recorded
timecode is generated on the receiving VTR in
accordance with the Function menu setting.
• When receiving files, files with regenerated timecode
and files for which original timecode is copied cannot be
recorded on the same tape.
Selecting the Output Audio Channel
of e-Monitor
To change the output audio channel of e-monitor, a setting
must be made on the Setup menu ITEM-253: E-
MONITOR AUDIO SELECT on the VTR.
For details on setup operation, refer to the Operation
Manual supplied with the VTR.