Entering The Uefi Firmware Setup; Exchange The Battery; Figure 11: Removed Front Panel, View At Battery - GE PACSystems RXi-XP IPC Hardware Reference Manual

3.10 Entering the UEFI Firmware SETUP

To enter SETUP during the initial power-on sequence, press the DELETE key during the boot up sequence. Also
see the applicable on-screen messages when prompted.
If the RXi Box IPC-XP does not perform as described above, some damage may have occurred in shipping or
chapter ʹSupport, Service, and Warranty Informationʹ for further instructions.
the board is not installed or setup properly. Contact GE Intelligent Platforms technical support as described in

3.11 Exchange the Battery

ATTENTION
The information described in this chapter is for service technician only!
There is danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent to
Rayovac BR2032 type.
Dispose used batteries according to instructions of GE Intelligent Platforms and applicable local regulations.
INSTRUCTION
1. Remove power from the IPC.
2. Loosen the four captive screws on the IPC's top
cover and remove it.
Figure 11: Removed top cover, view at battery
PACSystems RXi Box IPC-XP Hardware Reference Manual GFK-2990 36
Internal