Reboot; Repeaters - GE MDS RCL220 Manual

RCL220_manual_v3-draft.doc
3.2.16

REBOOT

Usage: REBOOT {SAME} {APP1} {APP2} {OTHER}
Description: Reboot the radio's firmware.
NOTE: CMD=1 command not supported.
Access Level: Administrator
Optional Arguments:
SAME Write Only for all users, starting at Administrator. Same Image
APP1 Write Only for all users, starting at Administrator. Application Image 1
APP2 Write Only for all users, starting at Administrator. Application Image 2
OTHER Write Only for all users, starting at Administrator. Other Image
3.2.17

REPEATERS

Usage: REPEATERS {CLEAR} {CHANMASK=<chanmask>} {LASTBFREQ3=<lastbfreq3>}
{LASTMFREQ3=<lastbfreq3>} {LASTBFREQ4=<lastbfreq4>}
{LASTMFREQ4=<lastmfreq4>}
Description:
Access Level: Administrator
Optional Arguments:
CLEAR
CHANMASK=<chanmask> Repeater channel N availability. <chanmask> is a
bitmap which sets the accessibility of four channels. Bit zero through three mask
channels one through four, respectively. Setting a bit to 1 makes the corresponding
channel available; setting it to 0 makes it unavailable.
Acceptable value range: 0 – 15
LASTBFREQ3=<XXX.XXXXXX> Committed channel 3 B(Repeater) Frequency
Acceptable value range: 216-222 MHz Channels
05-XXXXA01 Version 3 Draft Page 44 of 79 9/20/2016