HP Z8 G4 Product End-Of-Life Disassembly Instructions page 2

Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Screwdriver
Pliers
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove/disengage any security devices that prohibit opening the workstation
2. Disconnect the power cord from the electrical outlet and then from the workstation.
3. Disconnect all peripheral device cables from the workstation.
4. Remove the access panel.(see Figure 1 below)
5. Remove the internal parts.(see Figure 2-4 below)
6. Remove the system fans and brackets. (see Figure 5-19 below)
7. Remove the Slim ODD and cable.(see Figure 20-24 below
8. Remove all the FIO cable from chassis.(see Figure 25-34)
9. Remove all the installed parts from MB.(see Figure 35-36)
10. Remove the CPU cooler.(see figure 37-42)
11. Remove the FIO module.(see fugure 43-55)
12. Remove the HDD bracket.(see figure 56-58)
13. Remove the MB from chassis.(see figure 59-64)
14. Remove the PCIe slot cover.(see figure 65)
15. Remove the PSU.(see figure 66)
16. Remove the right side panel.(see figure 67-70)
17. Remove the PDB out of chassis.(see figure 71-73)
18. Remove the BM SATA cable.(see figure 74-76)
19. Remove the top panel from chassis.(see figure 77-78)
20. Remove the front panel from chassis.(see figure 79-80)
21. Remove the hood sensor bracket and HDD Deco bracket.(see figure 81-82)
22. Remove the front handle pocket.(see figure 83-91)
23. Remove the rear handle pocket.(see figure 92-95)
24. Remove the ODD bracket cover.(see figure 96-100)
25. Remove PSU outside screws.(see figure 101-102)
26. Remove PSU PCB screws.(see figure 103-104)
27. Cutoff the cable tie inside PSU.(see figure 105-108)
28. Disconnector fan header from PSU PCA. (see figure 109-110)
29. Remove the capacitors over 2.5mm. (see figure 111-112)
30. Remove 2pcs fan from PSU. (see figure 113)
EL-MF877-00
Template Revision B
PSG instructions for this template are available at EL-MF877-01
Tool Size (if
applicable)
T-15/T30/
PH2/PH0/V6
Page 2