Installing Optional Hardware; Available Devices; Installation Locations; Installation Precautions - Yamaha Motif XS Series Service Manual

INSTALLING OPTIONAL HARDWARE

Available devices

The following optional devices can be installed to the
MOTIF XS.
mLAN16E2

Installation locations

mLAN16E2
MOTIF XS6
Rear cover for the mLAN16E2
MOTIF XS7
USB
ETHERNET TO HOST TO DEVICE LCD CONTRAST
POWER AC IN
ON/ OFF
Rear cover for the mLAN16E2
DIMM
MOTIF XS6
Bottom cover for the DIMM
MOTIF XS7
Bottom cover for the DIMM
MOTIF XS8
Bottom cover for the DIMM
DIMMs
MIDI FOOT SWITCH FOOT CONTROLLER ASSIGNABLE OUTPUT OUTPUT A/D INPUT
DIGITAL OUT THRU OUT IN ASSIGNABLE SUSTAIN 2 1 R L R L/MONO PH PH ONES ONES R L GAIN
MOTIF XS6/MOTIF XS7/MOTIF XS8

Installation Precautions

Before installing the optional hardware, make sure you
have a Philips screwdriver and ample space to work.
WARNING
• Before beginning installation, switch off the power to the
instrument and connected peripherals, and unplug them
from the power outlet. Installation or removal of any
devices should be started ONLY after the instrument
(and the optional hardware) returns to normal room
temperature. Then remove all cables connecting the
instrument to other devices. (Leaving the power cord
connected while working can result in electric shock.
Leaving other cables connected can interfere with work.)
• Be careful not to drop any screws inside the instrument
during installation. (This can be prevented by keeping
the optional units and cover away from the instrument
while attaching). If this does happen, be sure to remove
the screw(s) from inside the unit before turning the
power on. Loose screws inside the instrument can
cause improper operation or serious damage.
• Install the optional units carefully as described in the
procedure below. Improper installation can cause shorts
which may result in irreparable damage and pose a fi re
hazard.
• Do not disassemble, modify, or apply excessive force to
board areas and connectors on optional units. Bending
or tampering with boards and connectors may lead to
electric shock, fi re, or equipment failures.
CAUTION
• It is recommended that you wear gloves to protect your
hands from metallic projections on optional units and
other components. Touching leads or connectors with
bare hands may cause fi nger cuts, and may also result
in poor electrical contact or electrostatic damage.
• Be careful of static electricity. Static electricity discharge
can damage the IC chips on the Plug-in board. Before
you handle the optional Plug-in board, to reduce the
possibility of static electricity, touch unpainted metal
parts or a ground wire on the devices that are grounded.
• Handle the optical units with care. Dropping or
subjecting them to any kind of shock may cause
damage or result in a malfunction.
• Do not touch the exposed metal parts in the circuit board.
Touching these parts may result in a faulty contact.
• When moving a cable, be careful not to let it catch on the
circuit Plug-in board. Forcing the cable in anyway may
cut the cable, cause damage, or result in a malfunction.
• Be careful not to misplace any of the screws.
• Do not use any screws other than what are installed
on the instrument. Use of incorrect screws can cause
damage.
55