About The Preset Memory No - Sony VPL-FE40L Operating Instructions Manual

Setting items Functions
Adjust Signal
APA (Auto Pressing ENTER key automatically adjusts the
Pixel "Phase," "Pitch" and "Shift" to position the image
Alignment) correctly on a screen.
Phase Adjusts the dot phase of the panel and the computer
signal.
Adjust the picture to the point where it looks clearest.
Pitch Adjusts the horizontal size of the picture from a
computer.
The higher the setting, the wider the picture. The lower
the setting, the narrower the picture. Adjust the setting
to match the number of dots of the input signal.
Shift Adjusts the position of the picture.
• H: As the setting for H (horizontal) increases, the
• V: As the setting for V (vertical) increases, the
Notes
• Note that if the projector is used for profit or for public viewing, modifying the original picture by
switching to the aspect mode may constitute an infringement of the rights of authors or producers,
which are legally protected.
• For Aspect, "Aspect" itself or a part of the setting items cannot be displayed on the screen
according to the input signal. Also, "Full 1" and "Full 2" may become the same images.

About the Preset Memory No.

This projector has 41 types of preset data for
input signals (the preset memory). When a
preset signal is input, the projector
automatically detects the signal type and
recalls the data for the signal from the preset
memory to adjust it to an optimum picture.
The memory number and signal type of that
signal are displayed on the Infomation menu
(See page 38). You can also adjust the preset
data through the Screen menu.
This projector has 20 types of user memories
for Input-A into which you can save the
setting of the adjusted data for an unpreset
input signal.
When an unpreset signal is input for the first
time, a memory number is displayed as 0.
When you adjust the data of the signal using
the Screen menu, it will be registered in the
projector. If more than 20 user memory
picture moves to the right, and as the setting
decreases, the picture moves to the left. Use < / ,
key to adjust the horizontal position.
picture moves up, and as the setting decreases, the
picture moves down. Use M / m key to adjust the
vertical position.
items are registered, the newest memory
always overwrites the oldest one.
See the chart on page 50 to find if the signal
is registered in the preset memory.
Note
When the aspect ratio of input signal is other
than 4:3, a part of the screen is displayed in
black.
Initial setting
Set according to
the input signal
31
The Screen Menu