Before You Use Your Receiver - Sony STR-DE545 Operating Instructions (Receiver) Operating Instructions Manual

Notes
• The front balance, rear balance, center level, and rear level are
shown in the display during adjustment.
• Although these adjustments can also be made via the front
panel using the LEVEL menu (when the test tone is output, the
receiver switches to the LEVEL menu automatically), we
recommend you follow the procedure previously described in
this section and adjust the speaker levels from your listening
position using the remote control.
z
When setting the volume levels for each speaker
Let's assume that you have matched the sound levels of all the
speakers using the test tone. Although this lays the foundation
for high quality surround sound, it may be necessary to make
further adjustments while listening to playback of actual
software. This is because most software contains center and rear
channels recorded at slightly lower levels than the two front
channels.
When you actually play back software recorded in multi channel
surround, you will notice that increasing the center and rear
speaker levels produces a better blend between the front and
center speakers and greater cohesion between the front and rear
speakers. Increasing the level of the center speaker about 1 dB,
and the rear speakers about 1~2 dB is likely to produce better
results.
In other words, in order to create a more cohesive soundstage
with balanced dialog, we recommend that you make some
adjustments while playing your software. Changes of only 1 dB
can make a huge difference in the character of the soundstage.
20
Before You Use Your
Receiver
Before turning on the receiver
Make sure that you have:
• Selected the appropriate front speakers (see "7
SPEAKERS selector" on page 23). (STR-DE545 and STR-
SE501 only).
Checking the connections
After connecting all of your components to the receiver,
do the following to verify that the connections were made
correctly.
1/u Function buttons
MULTI CHANNEL DECODING
? / 1
DIMMER DISPLAY
INPUT MODE
SPEAKERS
R ON r OFF
A
VIDEO DVD/LD TV/SAT 5.1CH INPUT CINEMA STUDIO
B
A B C
MD/TAPE CD TUNER AUX SOUND FIELD
PHONES
A. F. D. 2CH MODE
1
Press ?/1 to turn on the receiver.
2
Press a function button to select a component
(program source) that you connected (e.g., CD
player or tape deck).
3
Turn on the component and start playing it.
4
Rotate MASTER VOLUME to turn up the volume.
If you do not obtain normal sound output after
performing this procedure, look for the reason in the
following checklist and take the appropriate measures to
correct the problem.
There is no sound no matter which component is
selected.
, Check that both the receiver and all components
are turned on.
, Check that the volume level on the display is not
set to VOL MIN by turning the MASTER
VOLUME.
, Check that the SPEAKERS selector is not set to
OFF or to a position for front speakers that are not
connected to the receiver (see "7 SPEAKERS
selector" on page 23). (STR-DE545 and STR-SE501
only)
, Check that all speaker cords are connected
correctly.
, Press the MUTING button to turn off the indicator.
MASTER VOLUME
PRESET
– TUNING + SHIFT
– TUNING + MEMORY
BASS BOOST TONE
FM/AM FM MODE
MASTER VOLUME
I i
– +
BASS
MUTING
LEVEL SET UP BOOST TONE
SUR NAME
BASS/
TREBLE ENTER