Sony DFP-R3000 Quick Start Manual page 19

Mode Name
1 SDDS
2 SDDS 7.1CH
3 SDDS 6CH
4 SDDS 5.1CH
5 SDDS 4CH
For each Preset, graphic and parametric equalization/channel level trim can be switched
on or off, surround delay processing can be switched on or off, the number of seconds
of surround delay can be set if surround delay processing is switch on, a volume offset
for the preset can be specified, and the sub-woofer low pass filter frequency can be set.
To select and set these parameters, use the appropriate control in the Preset
Configuration area of the screen. If the test signal generator is running, only the
preset offset, surround channel delay and EQ on/off switch controls, surround delay
setting, and the sub-woofer low pass filter frequency controls are active.
After making modifications to a Preset Configuration, use the Send Config to DFP
button to send the changes to the DFP-2500 decoder from your connected laptop. Even
if the Send Config to DFP button is not used, the Setup Software will automatically
send the new parameters to the DFP-2500 decoder when the Exit button for the Preset
Configuration screen is clicked.
Meaning
Eight inputs sent directly to eight outputs
#1 except LC and RC mixed into L,C,R; SW to SW, LC, and RC outs
#1 except LC and RC mixed into L,C,R; SL+SR to SL out; SW to LC and
RC
#1 except LC and RC mixed into L,C,R; SW in to SW out only
#1 except LC and RC mixed into L,C,R; SL+SR to SL out; SW to SW only