Signals From Nc (Db10); Transverse Axes (P1) - Siemens SINUMERIK 840Di Function Manual

Detailed Description

2.12 Transverse axes (P1)

DB10
DBX56.2 Acknowledge EMERGENCY STOP
Special cases, The EMERGENCY STOP state cannot be reset using the interface signal:
errors, ...... DB21, ... DBX7.7 (reset).
Corresponding to .... DB10 DBX56.1 (EMERGENCY STOP)
DB10 DBX106.1 (acknowledge EMERGENCY STOP)
DB11 DBX0.7 (mode group reset)
2.11.2

Signals from NC (DB10)

DB10
DBX106.1 EMERGENCY STOP active
Edge evaluation: no
Signal state 1 or The NC is in the EMERGENCY STOP state.
edge change
0 → 1
Corresponding to .... DB10 DBX56.1 (EMERGENCY STOP)
DB10 DBX56.2 (acknowledge EMERGENCY STOP)
2.12 Transverse axes (P1)
2.12
No signal descriptions required.
2-114
Signal(s) updated: cyclic
NC/PLC Interface Signals (Z1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0