Table of Contents
Advertisement
5.
Release the shipping stops on each MSI in order to free the weighing mechanism.
Loosen screws ' A ' and rotate both shipping stops inward until the underside slots
slide around the screws 'B' . Tighten screws ' A ' to secure in place.
shipping stop
6.
The idlers in the weighing area must be properly aligned and leveled by shimming
the scale idler (S#), the two approach (A#) and the two retreat idlers (R#) until they
are within ± 0.8 mm (1/32") of each other. Be sure to check that the idlers are
centered and squared to the conveyor during the shimming process.
A 2
alignment of idlers
A2 to R2 to be within
± 0.8 mm (1/32")
Page 8
Milltronics MMI Belt Scale – INSTRUCTION MANUAL
'B' shoulder bolts
C
A 1
S 1
material flow
' A ' screws
C
idlers must be square to stringers
S2
R 1
shipping stop
center of idler
to be in line
90°
R 2
7ML19985DR02
Advertisement
Table of Contents
