Siemens SINUMERIK 840D sl Commissioning Manual page 14

Introduction
2.2 Supplementary conditions
● The SINUMERIK Software Update Tool cannot be used if the following products are
installed on the NCU:
– HMI PRO
– Applications that have been created with SINUMERIK Integrate Create MyHMI /3GL
– MCIS, ePS, SINUMERIK Integrate for Production
● Certain options cannot be automatically updated and require manual reworking. In as far
as these are recognizable by the tool, a corresponding message is output.
The following table shows the corresponding overview:
14
Automatic upgrading
CNC software includ‐ Yes
ing options (exceptions
see below)
Compile cycles No (check, possibly update
(Run MyCC) manually)
SINAMICS OA No (check, possibly update
manually)
Additional languages No (check, possibly update
manually)
PLC program No (check, possibly update
manually)
Recognition through update script
-
Yes (note is output)
Yes (note is output)
Yes (note is output)
No
SINUMERIK Software Update Tool
Commissioning Manual, 03/2018, A5E42187770B AA