Filling The Water Tank; Filling The Brew Basket - KitchenAid 5KCM0802 Manual

OPERATING THE COFFEE BREWER CMD + SHIFT CLICK TO CHANGE COPY

Filling the water tank

The water tank holds between 2 and 8 cups
of water (.15L each) for brewing. Since you
are able to select the number of cups you'd
like to brew each time, you do not have to
fill the water tank with the exact amount of
water you need. The Coffee Maker will use
the correct amount of water for the number
of cups you select.
NOTE: If the water in the tank has been sitting for a while and you wish to start fresh,
select 8 cups and press the BREW button (without coffee in the brew basket). This will
cycle through any stale water in the tank.
HELPFUL TIP: For best taste and brewing results, make sure you have enough water in
the tank for the number of cups you want to brew.

Filling the brew basket

Lift the filter clip and place a #4 paper
1
coffee filter in the brew basket. Press
the paper filter in to the sides of the
brew basket and clip it into place with
the filter clip. Should you prefer to brew
without the filter clip, you can easily
remove it by snapping it out of place.
NOTE: Pre-wetting the paper filter is
not required.
Slide the water tank lid back, and fill
1
the water tank with fresh, cool water to
the desired cup level as indicated on the
water tank view. Because of the design
of this Coffee Brewer, it may take a
moment for the water to enter the place
in the tank where you can view the
water level. Close the water tank lid.
Using the dosage recommendation on
2
the filter clip (or see "Coffee dosage
guide" for conversion chart), fill the
paper filter with the desired amount
of ground coffee. Then, close the brew
basket door.
15