Oven Light - GE JRP20 Owner's Manual

Oven Light

Non-Self-Clean Oven Interior
With proper care, the porcelain enamel finish on the
you wear rubber gloves when cleaning the oven.
Soap and water will normally do the job. Heavy
spattering or spillovers may require cleaning with a mild
abrasive cleaner. Soap-filled scouring pads may also be
used.
(such as tomatoes, sauerkraut, fruit juices or pie filling)
to remain on the surface. They may cause a dull spot
even after cleaning.
Household ammonia may make the cleaning job easier.
Place 1/2 cup in a shallow glass or pottery container
in a cold oven overnight. The ammonia fumes will help
loosen the burned-on grease and food.
Wire cover holder
Socket
3 "
1 2
Max
length
Tab
Glass cover
18
(on standard clean models or on lower oven)
Oven Light Bulb
(on some models)
CAUTION
oven light bulb, disconnect the electrical
power to the oven at the main fuse or
circuit breaker panel.
completely.
To remove the cover:
1. Hold a hand under the cover so it
doesn't fall when released. With fingers of
the same hand, firmly push back the wire
Oven Light Bulb
(on some models)
NOTE: The glass cover (on some models)
should be removed only when cold.
Wearing latex gloves may offer a better
grip.
electrical power to the oven at the main
cool completely before removing it. For
your safety, do not touch a hot bulb with a
To remove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear
the grooves of the socket. Remove the
bulb.
package directions.
and switches because it could cause a short circuit
and result in sparking or fire.
improperly. (The sensor is located at the top of the
oven.) Carefully wipe the sensor clean after each oven
cleaning, being careful not to move the sensor as a
change in its position could affect how the oven bakes.
handles or any exterior surface of the oven, cabinets
or painted surfaces. The cleaner can damage these
surfaces.
cover.
2. Replace bulb with a 40-watt appliance
bulb.
To replace the cover:
1. Place it into grooves of the light
receptacle. Pull wire forward to the center
of the cover until it snaps into place.
2. Connect electrical power to the oven.
To replace:
Put in a new 40-watt appliance bulb.
Place the tabs of the glass cover into the
grooves of the socket. Turn the glass
cover clockwise 1/4 turn.
Note:
a standard 40-watt household bulb.
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
49-80715 Rev. 1