Table of Contents
Advertisement
28/32
Bosch Rexroth AG
Decommissioning
9.3
Spare parts list
In case of questions concerning repair works, please contact the competent
Rexroth service or the central service department:
Bosch Rexroth AG
Service Industriehydraulik
Competence Center Lohr
Bgm.-Dr. Nebel-Str. 8
97816 Lohr am Main, Germany
Phone: +49 (0) 93 52 - 18 0
spareparts.bri@boschrexroth.de
The addresses of our sales and service network are given under:
www.boschrexroth.com/adressen
10
Decommissioning
The bladder-type accumulator is a component that must not be decommissioned.
For this reason, the chapter does not contain any information in this manual. How
to disassemble and replace the bladder-type accumulator is described in chapter
11 "Disassembly and replacement".
11
Disassembly and replacement
Discharge the accumulator via the discharge facility of the system. Please note
that the pre-filling pressure still exists on the gas side after hydraulic relief
Please decide whether a remaining gas pressure in the bladder-type accumulator
is required or reasonable.
For safety reasons, we recommend to discharge the gas pressure and to clearly mark
this on the accumulator, if the system is decommissioned for a longer time or forever.
In order to keep the accumulator depressurized, the gas valve insert must be removed.
11.1
Required tools
For the disassembly of the bladder-type accumulator, you need:
•
Charging and test device according to RE 50170
•
Open-end wrench key, information concerning the wrench sizes is given in
chapter 6 "Installation"
•
Appropriate lifting gear
Type HAB..-4X | RE 50170-B/10.08
Advertisement
Table of Contents
