Setting Up The Flat-Panel Monitor; Power Management System - Dell PowerEdge Rack Console 15FP User Manual

F i g u r e 1 - 3 . B a c k V i e w

Setting Up the Flat-Panel Monitor

Follow the steps below to set up the flat-panel monitor.
• Ensure flat-panel monitor has been connected to an AC power source. See the Rack
Installation Guide.
• You can power on this flat-panel monitor by using either one of the following two
methods.
– Automatically: Pull the flat-panel monitor tray out until it locks, and then grasp the
monitor by its handle and rotate it up to a desirable position. The flat-panel monitor
automatically turns on when it reaches approximately a 90° angle.
– Manually: Press the Power button located at the back side of the bezel.
• To adjust the height, grasp the monitor at both sides and use equal pressure on both sides
to move it up and down.

Power Management System

This flat-panel monitor complies with the VESA DPMS (version 1.0p) power management
standard. The VESA DPMS proposal provides four phases of power saving modes by
detecting horizontal or vertical sync signal. See Table 1-2 for information about power
consumption for each different power management mode.
When the flat-panel monitor is in the power saving mode or detects an incorrect timing, the
monitor screen will be blank and the power button LED indicator color will be half-bright
blue.
1-7
U se r 's Gui d e